When I test fit the mini, I feel that if I leave the hands and the right arm off-painting them separately and attaching them at the end-I’ll have a much easier time reaching the armor on the inside of the myrmidon’s arms and around his head. When painting, the goal is to have all the model’s areas as accessible to the brush as possible, so a little thinking needs to happen at this stage about how to make the job easier. Sometimes there are seam lines left behind from the molding process that have to be scraped off or cleaned up as well, but these castings are incredibly clean and ready to go.Īssembling the Miniature (Sub Assemblies and Pinning) I can use a retractable hobby blade to scrape the nubs off in several passes.Īfter all the excess sprue resin is removed, the next step is assembling the parts. The Gale Force Nine resin is a joy to work with and very easy to carve. Some resins are very hard, and require metal files to remove them. The next step is to remove those little nubs. I continue this process for all the pieces. Always use a filter mask and safety glasses. This process kicks up a surprising amount of resin dust, so it needs to be done in a well-ventilated area. That way, if I have an accident and score the resin, it’s not in a critical or visible location. If the surface is going to be hidden, I might just cut a sprue all the way down with the Dremel. With a cutting wheel attached and using a low speed (so as to not melt the resin), I begin trimming off the sprues, usually leaving a little stump about a millimeter or two high. Mine is cordless and rechargeable, with a pistol grip and (most importantly) variable speeds. The Dremel is a miniature-sized power drill used in hobbies. On this model, the sprues all look like cylinders attached to the pieces.ĭremel tools, a retractable blade, files, and sandpaper are all common tools used to remove excess resin. ![]() ![]() ![]() I’m using the term “sprue” to describe the excess resin that is not part of the finished model. Mold making has a few technical terms-sprue, runner, and gates-to describe the channels in the molds where resin is poured in to form the model. Before painting can start, the model has to be prepped and assembled, and the first step is to remove the sprues. The earth myrmidon comes in five parts, all cast in resin-base, stone on base, body, right arm, and hands holding a club.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |